This device has been manufactured in accordance with our certified environmental management system (ISO 14001). The device conforms to the EU guideline 1999/5/EG, as attested by the CE mark. The trademarks used are owned by Siemens AG or their respective owners. The information provided in this document contains merely general descriptions or characteristics of performance which in case of actual use do not always apply as described or which may change as a result of further development of the products.Īn obligation to provide the respective characteristics shall only exist if expressly agreed in the terms of contract. Never allow the telephone to come into contact with staining or aggressive liquids such as coffee, tea, juice, or soft drinks.įor information on telephone maintenance Æ. If you encounter any problems, contact the service personnel.ĬE (customer equipment) does not continue to support emergency dialing after loss of mains power, if battery back up and power fail switchover to emergency analogue phones is not available. Never open the telephone or a key module. Using other accessories may cause a hazard and will invalidate the warranty and the CE mark. Important Notesĭo not operate the telephone in environments where there is a danger of explosions. Your communications platforms does not support this function - please contact your service personnel.The function has not been configured for your telephone - please contact your service personnel.This may be due to one of the following reasons: You may find that some functions you wish to use are not available on your telephone. They describe all functions you can use from your telephone. These operating instructions describe the optiPoint 500 entry telephone on your HiPath 500 and HiPath 3000 / 5000. Overview of Functions and Codes (Alphabetical).Transferring Calls Directly to the Executive (Only in an Executive/Secretary Group).Team and Executive/Secretary Functions With Assigned Trunk Lines.Accepting a Call for Another Member of Your Team.Resetting Services and Functions (System-Wide Cancellation for a Telephone).
Saving Function, Procedures and Appointment.Busy Override - Joining a Call in Progress.Activating Tone Dialing/DTMF Suffix-Dialing.Turning the Call Waiting Tone On and Off.Preventing and Allowing Call Waiting (Automatic Camp-On).Talking to Your Colleague With a Speaker Call.Answering Calls from the Entrance Telephone and Opening the Door.Accepting a Specific Call for Your Colleague.Adjusting the Receiving Volume During a Call.Switching to the Party on Hold (Toggle).HiPath AllServe, Hicom 150 E/H HiPath 3000 HiPath 5000 RSM.High Speed Counter and Encoder Module SIMATIC 505.Hicom cordless EM Convenience mobile unit 2000C pocket.